|
How To Apply StickyScreen
Projection Films
To apply these films to glass, acrylic, window or any rigid transparent surface, have the following items ready to use:
• StickyScreen Projection Film
• Spray bottle with a water/soap solution: 1 qt water to ½ teaspoon of amber colored baby shampoo is recommended
• Window tint squeegee or “Hard Card”
• Rubber-Blade squeegee
• Paper towels and/or dry soft cloth (preferably microfiber)
• Masking tape to mark the boundaries of the screen (if smaller than the substrate)
• Razor Knife or Sharp Scissors to cut the film to size or a particular shape if desired
|
1) Thoroughly clean the substrate of dust,
dirt or oils using the water/soap
solution, dry the surface using
the rubber-blade squeegee. Closely
inspect the surface for any
contaminants and re-clean the surface
if necessary. Do Not use any
ammonia based products before or
after the installation of your Sticky Screen.
2) Use the tape to mark the area that the
film will be applied (if the film is
smaller than the substrate.) This can
be marked from the opposite side.
3) Carefully peel the release liner from
one corner of the film (Tip: put a piece
of scotch tape on both sides of a
corner and pull apart to separate
the film from the liner), thoroughly wet the adhesive side of the film with the water/soap solution as you pull back the liner.
|
4) Place the film carefully on the
substrate being careful not to
fold or crease the film
while aligning the edges to
the tape.
5) Once in position spray the
surface with the water/soap
solution and remove the
water and any air bubbles
between the film and substrate
with the Window Tint squeegee
or Hard Card by carefully squeezing the water from the center of the film toward the edges.
6) Remove any excess water with paper towels or clean soft cloth.
|
